Raw wool

At some point, when I have my own land with enough space, I want to be able to raise sheep or alpacas for wool.  Before taking on any project, especially something like animals, you should do your best to know what you are getting yourself into before you do it.  I figure that the way to learn about wool would be to go and get some raw wool and learn how to card, spin, and felt by hand to see if those are things that I am really going to want to do.  So I went to a local farm and bought the wool from two sheep (Shetland Sheep if you like this wool).

DSC_0050The first step to take with this wool is to wash it.  Fresh wool is full of lanolin which makes the wool greasy and hard to work with.  It is also what you are probably smelling.  I found many ways to wash wool, but the one that seemed the most practical to me was to put it in the washing machine.  However, you can’t just throw it in and turn on the machine.  You put the wool in the washer and set it to soak cycle on hot.  You can buy special wool wash, but I used my own homemade laundry detergent.  Once it fills make sure it DOES NOT AGITATE.  This causes felting.  I turned my machine on the soak cycle thinking that it would not agitate and it did.  I’m not sure to what extent the wool may have started felting, but hopefully not too much.  Let it soak for about 2 hours then drain.  Spinning is ok.  Repeat this cycle without the detergent until the wool is clean.  I did one wash with soap and 2 to rinse.  The wool is not super clean, but the water was no where near as black as it was to start with.  Then I laid it out on a tarp in the sun to dry.  Once it was really dry, I stored it in a large paper bag, not in a moist area.  I probably won’t get to the next step for a while, but I had to get the wool in spring when it was available.

Share This:

I am really hoping that once we get established that I will be getting some alpacas. Then I will need help with the spinning part for sure. I’m hoping to try some felting out real soon, but it keeps getting put off. Hopefully not much longer, I promised Doug a really cool mountain man hat!

No Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

Building
Additon Step 2: Make a Flat Spot

This is the second area I am flattening out for the addition. The other side was put up in a hurry, so I forgot to take pictures. Obstacle 1 on this side is the tree stump. Obstacle 2 is the gap alongside the house. I stacked rocks to form a …

Building
6
Change in Plans…Again…

We have been hard at work on the cordwood house for a couple a months now.  Although it appears to me as though we have hardly been working.  Everything is moving painfully slowly and outside situations keep putting a hold on the the build for one annoying reason or another.  …

Building
1
Mini Cordwood Build: Gathering Flooring Tiles

The floor we intend to use is a dirt floor.  I will get into the details of that aspect when we do it, but it is not just dirt beneath your feet.  It ends up nicely sealed so that you aren’t getting dirt all over the place.  What I am …